A voice note that opens with ten seconds of rustling. A song where you only need the chorus. A podcast recording with a long goodbye at the end. Each one needs the same fix: keep the good part and drop the rest. This page lets you trim audio online in a few clicks, inside your browser.
Open one sound file and its waveform becomes the timeline. Drag the two red handles to the part you want, add a fade in or a fade out if you like, and press Trim audio. It works as an audio trimmer for MP3, WAV, M4A, FLAC, OGG and most other sound files, and as a quick MP3 cutter when a song just needs to be shorter. The file never leaves your device.
How to trim audio online in three steps
- Choose a sound file, or drop it anywhere on the page. It opens with its waveform as the timeline, and a Sound only card on the stage.
- Drag the two red handles to the start and end of the part you want to keep. You can also drag the box between them to slide the whole part along, or type the times into Start and End.
- Press Trim audio, then save the new file. It keeps your file's name with _trimmed on the end, so song.mp3 comes back as song_trimmed.mp3.
Listen before you trim. Click the stage or press the space bar to play. The preview plays only the kept part and stops at its end, so you hear exactly where the new file will begin and finish.
Reading the summary before you save
Under the settings, a short summary keeps track of your choices. Keeping is the length of the part between the handles, and Dropping is how much of the file is left out. Saved as names the file you will get, such as "MP3, 192 kbps" or "WAV, 16-bit". The kept part is always at least 0.2 seconds long, and the handles never pass each other.
Set the start and end to the exact moment
The handles and the Start and End fields always agree, so you can drag roughly first, then fine-tune.
Typing a time, or using the playhead
Start and End each take a time in minutes and seconds, down to the hundredth, such as 1:05.50. Press Enter or click away to apply it, or press Esc to bring back the old time. Small buttons either side of each field nudge it a little earlier or later.
Beside each field is a Playhead button. Play the file, pause where the speech or music should begin, and press Playhead next to Start. Then do the same for End.
Keyboard keys on the waveform
- Space plays and pauses the preview.
- I sets the start at the playhead, and O sets the end at the playhead.
- With a handle focused, the left and right arrow keys move it one small step. Hold Shift to move it by one second.
These keys make it easy to cut MP3 files on a spoken word or the first note of a track: play, press I, keep listening, press O. A good audio trimmer lets you work by ear like this.
Add a fade in or a fade out
A hard cut in the middle of music can sound as if someone pulled the plug. A short fade smooths it over. Fade in brings the sound up gently from silence, and Fade out takes it down to silence. Each slider goes from Off up to 10 s.
The fades belong to the part you keep, not to the original file. The fade in starts at your Start, and the fade out ends at your End. So when you fade out audio partway through a song, the new file still ends softly, right at the end handle. As the panel says, "The fades start and end at the edges of the part you keep."
- Neither fade can be longer than the part you keep. Keep 6 seconds, and each slider stops at 6 s.
- If the two fades add up to more than the kept part, the Trim audio button is blocked, and a message gives both lengths. Shorten a fade, or keep a longer part.
- The fades show on the waveform as shaded ramps at each edge of the kept part.
- You hear the fades in the saved file only, not in the preview, so play the saved file to check them.
The file you get back: MP3 or WAV
Under Save as you choose between MP3, "Plays everywhere", and WAV, "Every sample kept". Each tile shows the size the file will be, so you can compare them before you press Trim audio.
| Your file | Saved as at first | MP3 bitrate |
|---|---|---|
| MP3 | MP3 | About its own: the nearest standard rate at or above it, from 32 to 320 kbps |
| WAV | WAV, 16-bit | 192 kbps, if you pick MP3 |
| M4A, FLAC, OGG and other sound files | MP3 | 192 kbps |
Keeping an MP3 near its own bitrate means a small 64 kbps podcast does not swell in size, and a 320 kbps song is not thinned out. Under 32 kHz an MP3 tops out at 160 kbps, and the Saved as line shows the rate your file will really get. An M4A comes back as a real MP3 (or a WAV, if you pick it), never as an .m4a.
Does trimming change the quality?
The kept part is always written as a new file, not copied byte for byte. A WAV is saved as a 16-bit WAV, with no compression. An MP3 is saved as a fresh MP3, which can lose a very little quality. If you will edit a recording more than once, trim the WAV, keep it as WAV, and make the MP3 last with WAV to MP3.
Private, free, and what this page does not do
This audio trimmer does all of its work in your browser tab. The file is read from your device, the trimmed copy is made there too, and nothing is uploaded. Our privacy policy explains what the site does collect.
It is free, with no account and no watermark, and it is not counted in the free daily limit, which applies to document conversions only. Most files have no size limit. Some kinds, such as WMA or AIFF, take longer and can be up to 2 GB. It works in current Chrome, Edge and Firefox.
This page keeps one part of one file at a time. It does not take a section out of the middle and join the ends. To cut one file into several parts, use Split audio.
If your sound is inside a video, Extract audio saves it as a file of its own, and Trim video shortens the video itself. Every sound tool on the site is in the audio tools directory.
Cut your file down to size
A voice note, a podcast or a song: the job is the same, keep the part that matters. Choose your file above, drag the handles or type the times, add a fade if you want one, and press Trim audio. The trimmed file is made on your device, and your original is never changed.